Off-Board (shelf) Vs On-Board (built-in) Chargers The application (On-board vs Off-board) will determine the proper way to route the cord sets for optimal fit, function, and performance. How To Route AC and DC Side Battery Charger Cord Set The charger case also has routing and securing locations for the AC and DC cord sets when they need to be routed to the opposite ends as shown in Figure 2-3.Ģ. For off-board applications an optional handle is available for ease of carrying. The charger dimensions and mounting hole locations are shown below in Figure 2-2. A poor thermal conductive material is plastic or wood, though charger should still perform well. This provides a strong base and good thermal conductive cooling. The preferred way to mount the charger for On-board use is with the charger base bolted to a 0.1 inch (2.5 mm) minimum thick metal plate. The best mounting orientations for this charger are shown below in Figure 2-1. Always allow for as much free air space around the charger as possible. Proper installation is important to achieve optimum performance and life from your new charger. All on-board applications will simply require a ring terminal DC cord set to wire to the main positive and negative terminals on the battery bank. Otherwise, it is pretty straight forward to install and use in an on-board application. Or, check the golf cart charger receptacle on your golf cart if you intend to use this charger in an off-board application. Refer to the DC side cord set legend below. If you are looking to purchase a new Lester Golf Cart Battery Charger click here to learn more and save BIG!!!! Getting Startedįirst,make sure you have the correct charger and DC side cord set for your application. If you have the 650W 36 Volt or 48 Volt version please refer to this How To Wire My 650W Lester Summit II Golf Cart Battery Charger Note:These wiring instructions will only apply to the 1050W version of this battery charger. Since Pete\’s gets a lot of calls concerning this issue, we are publishing these directions here for your convenience. Instead, they publish their manual online. Learn more about the Auto Voltage feature now.Īs is the trend, Lester does not include multi-page owners manuals with their products. It also has an auto voltage feature that will allow charging 36 volt & 48 volt applications as well. The 1050W version is specific for 24 volt applications and packs a punch at 25 amps. They work great in all applications though some configuring is required. These units are very well designed and universal. This is a resource for those needing directions on how to wire their Lester Summit II Battery Charger.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |